POLYCOAT 2C
A two component Aromatic Polyurethane coating , repair and resurfacing material
Solution Characteristics :
* Newtonic viscosity,
* High wetting characteristics,
* High penetration characteristics,
Usage :
* Colored or transparent types can be applied on almost every type of floor,
* On protective coatings,
* In areas where resistance to certain mild chemicals is required,
* Where non slip surfaces are required, ( special mix design)
* For repairing and / or renewing old surfaces, (special mix design)
Application :
* Stir well with the aid of an electrical hand mixer the content of the packages A and B before using them.
* Mix well component A and B (comply with mixing ratios given by the company)
* depending on weather conditions and surrounding temperatures ,the prepared mixture should be used between 15 -
45 minutes
* Discard any excess mixture and under no circumstances it should be returned back to the original package.
* Apply with a roller or a brush,
* Apply on dry non humid clean surfaces,
* For better results apply 50-150 gm/m² POLYCOAT -1C as a primer and leave to dry then apply POLYCOAT-2C,
Depending on the condition of the application surface coverage can vary, 200-300 g/m² for thin systems and 2-
2.5kg/m² for each 1mm thickness in the thicker system.
* Package should not be left open for a long time,
* Special thinner can be used to thin POLYCOAT-2C if required,
* Even though POLYCOAT - 2C will dry in 3-6 hours on the applied surface, but will only reach it's final strength after
24-48 hours therefore preferably no traffic should be allowed on that surface for a couple of days .
|
